OPPO R9s Teardown

Oppo R9s running on the Qualcomm Snapdragon 625 processor with Adreno 506 GPU. The phone has 4 GB RAM and 64 GB of internal storage which is expandable using microSD, up to 128 GB.

The Oppo R9s has a 5.5 inches Full HD, 1080 x 1920 pixels IPS display with a pixel density of 401 ppi. It has Gorilla Glass protection as well. Coming to cameras, it has a 16 MP front camera for selfies. It has a microUSB port for data syncing and charging. There is a fingerprint sensor present on the Oppo R9s as well, along with a accelerometer sensor. It is a dual SIM smartphone with support for 4G LTE, USB OTG, Wi-Fi, FM Radio, Bluetooth and GPS too.

The Oppo R9s runs on Android v6.0.1 (Lollipop) and all this is powered by a 3010 mAh battery. It measures 153 x 74.3 x 6.58mm with a total weight of 145 grams including battery.

For the freshest produce, find us on Facebook for the latest teardown news.

The first step is powered off the phone. And then remove the SIM card tray.

Remove two screws close to the microUSB port.

Pry up the display a little bit and insert a pick. Slide the pick along the edge until you can remove the back cover.

First we look at the back cover, there is a large area of graphite thermal paste on the back cover, the previous generation is not, the antenna contact surface plated with gold, to prevent corrosion, the previous generation is not used.

Let us look at the whole body, still using three-stage design, the chips on the motherboard and connector are wrapped with metal shield, the metal shield is also affixed with graphite heat paste

Remove two screws securing the metal sheet.

Disconnect the battery connector and other cables from the motherboard.

Remove all screws securing the motherboard.

Take out the motherboard.

Next, we carefully look at the motherboard, at first glance that there is nothing exposed electronic components, but careful observation is not, they are hidden under the black dispensing, and this moment gave us a big surprise, this means that these bare electronic components are fully protected, even the water droplets on the motherboard will not affect the normal work.

Two cameras are made by the Sunny, because the main camera supports focus, so joined the metal frame around

Remove the light sensor.

Remove the earpiece.

Uncover the black tape. Lift up the green tape, you can remove the battery.

Oppo R9s comes with a 3.85V, 3010mAh Li-polymer battery.

Remove all screws securing the bottom board and speaker module.

Disconnect four cables from the bottom board.

We found that the bare electronic components on the bottom board also use the dispensing process.

The speakers comes from the AAC, AAC also provide speakers for the iphone.

Qualcomm Snapdragon 625 processor, 4GB RAM and 64GB ROM


Leave a Reply

Your email address will not be published. Required fields are marked *