laptop parts
Register | Log In Your cart is empty
Home ::  Laptop Cooling Fan ::  HP ::  Envy 15-u010dx x360
Cooling Fan for HP Envy 15-u010dx x360

Click for larger image and additional views.
Product Description
  • SKU: LMFHP10113
  • Input: DC5V info
  • Output: N/A info
  • Condition: Original, Brand New info
  • Warranty: 12 Months info
  • Availability: In Stock, ready to ship

This is a brand new CPU Fan for HP Envy 15-u010dx x360 laptop, it is sold exactly as shown and does not include any additional parts or accessories. Be sure to remove your existing fan from your laptop and confirm it is as same as ours.

Related Laptops
Install Guide

How to remove or replace cooling fan on HP Envy 15-u010dx x360

1. Shut down your HP Envy 15-u010dx x360. Slide the battery lock latch and then slide the battery release latch to remove the battery.
2. Remove one screw securing the optical drive. Pull it out of the laptop.
3. Turn the laptop face down, and remove the rubber feet and two screws under the rubber feet, and then lift up and remove the end caps.
4. Remove eleven screws from the bottom cover.
5. Remove eight screws around the battery bay, two screws in the optical drive bay and one screw near the display hinge.
6. Turn the HP Envy 15-u010dx x360 right side up and separate the top cover with a thin card or guitar pick.
7. Sliding the guitar pick along the edges until the top cover fully released from the laptop.
8. Lift up the top cover. Be careful, there are four cables still connecting to the top cover.
9. Disconnect the power button cable, keyboard cable, touchPad cable, backlit cable from the motherboard.
10. Disconnect two antenna cables and remove the screw securing the wireless card. Take it away from its slot.
11. Disconnect the subwoofer cable from the motherboard, remove the three screws, and lift up and remove it from HP Envy 15-u010dx x360.
12. Disconnect the power connector board cable, LCD cables, speaker cable, optical drive cable, hard drive cable and USB connector cable.
13. Remove the screw securing the power connector cover. Lift up and remove it.
14. Remove the six screws securing the motherboard. Now you can remove the motherboard from the HP Envy 15-u010dx x360.
15. Disconnect the fan cable from the motherboard, and then remove the adhesive tape that secures the fan to the heatsink.
16. Remove three screws securing the fan.
Write Review

Ask a question

Shipping Money Back Warranty
Enter your email address to subscribe to our Newsletter.
Copyright © 2016 All rights reserved.