laptop parts
Register | Log In Your cart is empty
Home ::  Laptop LCD Cable ::  HP ::  Pavilion 17-e042sa
LCD Cable for HP Pavilion 17-e042sa

Click for larger image and additional views.
Product Description
Note: Make sure the LCD cable has same part number, photo as your original LCD cable!
  • SKU: LMCHP10055
  • Condition: Brand new info
  • Warranty: 12 Months info
  • Availability: In Stock, ready to ship in 24 hours

This is a brand new video cable for HP Pavilion 17-e042sa laptop. It is sold exactly as shown on the website. Be sure to remove your original LCD cable from your laptop and confirm it is as same as ours.

Related Laptops
Install Guide

How to remove or replace LCD cable on HP Pavilion 17-e042sa

1. Make sure the laptop is turned off. Slide the battery release latch to release the battery.
2. Loosen the screw that secures the service cover to the HP Pavilion 17-e042sa. Slide the service cover forward until it disengages from the computer. Remove the service cover.
3. Remove the screw that secures the optical drive to the HP Pavilion 17-e042sa. Using a small screwdriver push the optical drive out through the screw hole. The drive will move to the left a little bit. Now you can pull the optical drive out and remove it.
4. Remove two screws that secure the hard drive. Disconnect the hard drive connector cable from the motherboard.
5. Lift up on the hard drive black tab to release the hard drive from the hard drive bay.
6. Disconnect two antenna cables and remove the screw securing the wireless card. You can take it out of its slot.
7. Remove two screws that secure the keyboard to the laptop.Insert a thin tool into the keyboard release hole, and then press on the back of the keyboard until the keyboard disengages from the laptop.
8. Insert your fingers under the keyboard to separate the keyboard from the top cover. Turn the keyboard upside down and place it on the palm rest.
9. Unlock the keyboard cable connector and pull out the cable. You can remove the keyboard completely.
10. Remove fifteen screws that secure the top cover to the computer. Remove the six screws that secure the top cover to the HP Pavilion 17-e042sa.
11. Turn over the laptop and open the display. Disconnect the power button cable and touchpad cable from the motherboard.
12. Remove three screws that secure the top cover to the computer.
13. Start separating the top cover with a thin card, sliding the card along the edges. Now remove the top cover from the laptop.
14. Disconnect the LCD cable from the motherboard.
15. Remove the two screw covers and the two screws that secure the display bezel to the display assembly.
16. Start separating the bezel from the display back cover on the top of the display assembly. Insert a guitar pick or thin card between the bezel and cover and separate them from each other.
17. Separate the bezel from the display assembly and remove it from the HP Pavilion 17-e042sa
18. Unplug the cable from the left side of the web camera module.
19. Remove the six screws that secure the display panel to the display back cover.
20. Now you should be able to separate the screen from the display cover and place it front side down on the top cover. Be careful, the video cable still connected to the back of the screen.
21. Remove clear tape securing the video cable connector. Unplug the video cable and disconnect it.
Write Review

Ask a question

Shipping Money Back Warranty
Enter your email address to subscribe to our Newsletter.
Copyright © 2016 All rights reserved.